Waterworks Ludlow Handshower On Bar with Metal Handle Manual do Utilizador descarregar pdf

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST

LUDLOW

Handshower

INSTALLATION GUIDELINES

Page 1 of 2

11.1.2013

These guidelines have been prepared for the professional contractor to aid in the installation of:

LUDLOW HANDSHOWER ON HOOK (STYLE# LDHS01) & HANDSHOWER ON BAR (STYLE#

LDHS10) All dimensions are based on original specification and are subject to change and variation.

Please consult your Design Associate for current specifications.

SEE SERVICE PART DOCUMENT FOR PART ORDERING, AVAILABLE ON WATERWORKS.COM

Handshower

Style No. LDHS01

Handshower on Bar

Style No. LDHS10

SPECIFICATIONS:

Connection Type: 1/2" Female NPT

Recommended Pressure: 45psi

Restricted Maximum Flow Rate: 2.0gpm

IMPORTANT:

¾ A diverter or wall valve (sold separately) control

on/off/volume and must be installed for each fitting

that will have water flowing to it.

¾ To ensure this product is installed properly, you

must read and follow these guidelines.

¾ The owner/user of this product must keep this

information for future reference.

¾ Be sure your installation conforms to federal state,

and local codes. In the State of Massachusetts, all

installations must comply with the rules and

regulations set forth within 248 CMR.

¾ This product must be installed by a professional

licensed contractor and must be onsite prior to

rough-in, this allows the installer to visualize the

installation.

¾ Proper blocking in the wall is required.

¾ Inspect this product to ensure you have all the parts

required for proper installation.

¾ Use only a strap wrench or protected/smooth-jaw

wrench on any finished surface.

¾ The use of certain plumber's putty can stain stone or

tile surfaces

SUPPLY ELBOW INSTALL:

¾ See Figure 1 for Steps 1 & 2.

1. Determine the ideal location for the Ludlow

Handshower and stub out of the wall with a 1/2" NPT

nipple.

2. Hold the ESCUTCHEON to the wall with O-RING

behind it and thread the SUPPLY ELBOW to an

appropriate length 1/2 NPT NIPPLE (NOT

SUPPLIED) and make sure ESCUTCHEON is pulled

tight to the finished wall.

Figure 1

O-RING

ESCUTCHEON

SUPPLY ELBOW

FINISHED WALL

" NPT NIPPLE

(NOT SUPPLIED

HANDSHOWER BAR INSTALLATION (LDHS10 ONLY):

¾ See Figure 2 & Figure 3 for Steps 3-8.

3. Determine the ideal location for the HANDSHOWER

BAR that is close enough to the SUPPLY ELBOW.

4. Slide the ESCUTCHEONS up the ACCESSORY

POSTS to give access to the ACCESSORY SCREWS.

Dry fit the HANDSHOWER BAR to the wall and mark

ideal location , at a center-to-center dimension of

24", making sure the bar is level.

5. Unthread ACCESSORY SCREWS to remove the

WALL MOUNT PLATES.

6. Mount both WALL MOUNT PLATES, using the

ANCHORS and WALL SCREWS at the locations

marked in Step 4.

7. Simultaneously insert both ACCESSORY POSTS into

each WALL MOUNT PLATE and secure with

ACCESSORY SCREWS.

8. Slide the ESCUTCHEONS back down the

ACCESSORY POSTS and push firmly onto groove of

the WALL PLATES to secure. Note: you may need to

rotate the escutcheon while pressing firmly to finish

this installation.

1 2

INSTALLATION GUIDELINES 1

Resumo do Conteúdo

Página 1 - INSTALLATION GUIDELINES

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST LUDLOW Handshower INSTALLATION GUIDELINES Page 1 of 2 11.1.2013 These guidelines have been prepared f

Página 2

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST LUDLOW Handshower INSTALLATION GUIDELINES Page 2 of 2 11.1.2013 These guidelines have been prepared f

Comentários a estes Manuais

Sem comentários

Waterworks Ludlow Handshower On Bar with Metal Handle Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Acessórios para água Waterworks Ludlow Handshower On Bar with Metal Handle. Waterworks Ludlow Handshower On Bar with Metal Handle User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios para água Waterworks Ludlow Handshower On Bar with Metal Handle