Waterworks .25 Low Profile Three Hole Deck Mounted Lavatory F Manual do Utilizador descarregar pdf

Installation Guidelines

W A T E R W O R K S

Waterworks is a registered trademark of Waterworks Inc.04.30.07

.25 Low Profile Lavatory Faucet

These guidelines have been prepared for the professional contractor to aid in the installation of:

.25 LOW PROFLIE LAVATORY FAUCET WITH CROSS HANDLES (PTLS01-K) &

LEVER HANDLES (PTLS02-K) All dimensions are based on origin specification and are subject to

change and variation. Please consult your Design Associate for current specifications.

PTLS01-K (Cross Handles)

PTLS02-K (Lever Handles)

SIDE VALVE INSTALLATION

1. Remove the handle trim connector (3), gasket (4) and

plastic spacer (5) from the side valve (9). Do not remove

the lock nut (8), washer and lower gasket (7).

2. Determine the thickness of the mounting surface. If it is

less than 1

", slide the plastic spacer (5) onto the side valve.

If the surface is greater than 1

", do not use the spacer.

3. Insert the side valve into the hole in the mounting surface.

4. Slide the rubber gasket (4) onto the handle trim connector

(3). Thread the handle trim connector completely onto the

side valve (about 6 full turns) until it stops. If the connector

does not thread down completely, adjust the lock nut.

5. After the connector is on completely, tighten the lock nut

against the underside of the mounting surface to secure

the side valve.

6. Position the handle assembly over the valve then thread

the handle assembly (1) onto the side valve until it stops.

Hand tight is adequate; if this assembly is too tight, the

handle will bind.

7. Repeat these steps to install the second side valve.

SPOUT AND DRAIN INSTALLATION

Note: This faucet does not use a lift rod to operate the drain

stopper. Instead, it uses a simple pop-up drain that is closed

and opened by pushing down on the stopper.

8. Unthread and remove the spout mounting nut (13), metal

washer (12), and foam gasket (14) from the spout.

9. Insert the spout assembly (11) through the spout hole of

the mounting surface, reinstall the rubber and metal spout

washers then tighten the spout mounting nut to secure the

spout to the mounting surface.

10. Thread each supply hose (26) into the spout shank. Hand

tight is adequate, do NOT over tighten.

11. Connect each of the supply hoses to the adjacent side

valve (9) making sure the hoses are not pinched/kinked.

12. Remove the upper collar (18) from the pop-up drain

assembly and discard the upper gasket (19).

13. Set the upper collar in the lavatory drain opening using a

clear adhesive silicone.

"Ø

IMPORTANT

To ensure this product is installed properly, you must read

and follow these guidelines.

The owner/user of the faucet must keep this information

for future reference.

Be sure your installation conforms to local codes.

Refer to the specification and assembly drawings attached.

Faucet is sold partially assembled but shown fully

disassembled for illustrative and service purposes only.

Inspect this product to assure you have all parts required

for proper installation.

Use only a strap wrench or protected/smooth-jaw wrench

on any finished surface.

If possible, install the faucet assembly on the sink or

mounting surface before setting.

Do NOT use putty during this installation.

1 2 3

Installation Guidelines 1

Resumo do Conteúdo

Página 1 - Installation Guidelines

Installation GuidelinesW A T E R W O R K SWaterworks is a registered trademark of Waterworks Inc.04.30.07.25 Low Profile Lavatory FaucetThese

Página 2

14. Re-attach the lower drain assembly (22) using the gasket (20) provided then tighten until fully secured. A clear adhesive silicone may be used to

Página 3

Installation GuidelinesW A T E R W O R K SWaterworks is a registered trademark of Waterworks Inc..25 Low Profile Lavatory FaucetThese guideli

Comentários a estes Manuais

Sem comentários

Waterworks .25 Low Profile Three Hole Deck Mounted Lavatory F Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Acessórios para água Waterworks .25 Low Profile Three Hole Deck Mounted Lavatory F. Waterworks .25 Low Profile Three Hole Deck Mounted Lavatory Faucet with Metal Lever Handles User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios para água Waterworks .25 Low Profile Three Hole Deck Mounted Lavatory F